Messages

1

General Mach Discussion / Re: THC up/down dont moving Z axis

« on: May 28, 2012, 09:27:14 AM »

Thank you Steve, its already checked, but torch still moveless ...

Ojars

2

General Mach Discussion / Re: THC up/down dont moving Z axis

« on: May 25, 2012, 07:25:22 AM »

Thank you Ian and Hood for answer!
I try to ask these question to CS-Lab, because both controller an license file purchased from them.

Ojars

3

General Mach Discussion / Re: THC up/down dont moving Z axis

« on: May 25, 2012, 03:55:24 AM »

Sorry I dont understand about supporting, I think THC controller is stand alone device was makig torch up/down signal from tesion of plasma arc ... and its works ... CSMIO is input/output device instead paralel port ... I think it also works ... and in Mach3 diagnostic screen Torch up/down input LED lit, but nothing happens ...I have a feeling that there is something wrong with Mach settings.

4

General Mach Discussion / Re: THC up/down dont moving Z axis

« on: May 24, 2012, 01:14:19 PM »

I think Yes ... we purchase license file from Polands CS-Lab.

5

General Mach Discussion / Re: THC up/down dont moving Z axis

« on: May 24, 2012, 11:05:13 AM »

Yes, Z axis moving with Page up/down button or MPG.

6

General Mach Discussion / THC up/down dont moving Z axis

« on: May 24, 2012, 10:55:32 AM »

Hi.

We have plasma & mach3 with http://www.cs-lab.eu/en/index.php?m=gallery&s=show&fid=48&sort=&uinfo=CSMIOIPS_6_axis_CNC_Ethernet_Motion_Controller_STEPDIR motion controller & http://proma-elektronika.pl/cnc-plasma-thc-controller-torch-height-control/ THC controller . On diagnostic screen Torch up / Torch down LED lit, but Z axis dont moving, on "ports & pins/Mill options" "Allow THC UP/DOWN Control even if not in THC mode"  checked.

Thanks.

Ojars