Hello Guest it is April 12, 2021, 07:18:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gtxkid

Pages: 1 2 »
1
  Got it.
This is great.
We are finally getting somewhere.
Thanks

2
  Thanks Brett ;D ;D ;D
You got us a lot further along. ;)
We found the wiring wrong on the Z axis servo motor. ???

It was a great feeling to see  it move. 8)

  Is there a setting in Mach to tell Mach that it is looking at C32 board.
Problem we are having is setting up the steps per inch but when we
give it a move command it goes a totally different distance.

3
  I have a mill setup with Mach and been having a hard time getting it going.
I think we are close but i would like to call someone to go threw a quick trouble shooting. 

 

4
General Mach Discussion / Re: How do you change motor direction.
« on: March 26, 2013, 10:51:23 AM »
This is what i found out on LED's.

PCB = Printed Circuit Board, it is the plastic board.
STEP = Is the step or pulse pin, which takes the pulses to the driver.
DIR = Is the direction pin, indicates the driver the direction of rotation.
ERR = Fault line, lights if a driver faults.


5
General Mach Discussion / Re: How do you change motor direction.
« on: March 23, 2013, 09:56:48 AM »
  OK
Now that i discovered that you have to start it up in Smooth stepper i have it kinda working.
I need to know what the three leds by each axis mean on the C32 - Duel Port Multifunction CNC Board.
I print out the instruction's, but has no mention of the lights.
I need to do some trouble shooting.
I have middle light blinking on on Z axis.
 

6
General Mach Discussion / Re: How do you change motor direction.
« on: December 27, 2012, 12:35:58 AM »
  Merry Christmas guys.
Will be taking a short break.

7
General Mach Discussion / Re: How do you change motor direction.
« on: December 21, 2012, 12:42:18 PM »
 Well thanks to you i have made a big jump on it.   
Headed to shop again today.
I have manuals printed out for everything but the encoder.
Will need to identify the encoder for pin out on the GX320 from the way it looks.
Thanks

8
General Mach Discussion / Re: How do you change motor direction.
« on: December 21, 2012, 01:08:24 AM »
  Can anyone I.D. the 4 driver boards.
Who make's them.
I want to print out instructions on them.

9
General Mach Discussion / Re: How do you change motor direction.
« on: December 20, 2012, 11:23:12 PM »
  OK
Here is what i am working with, SEE PHOTO'S
I printed out the Manual that was the (Rev.4) hope it is the correct one.
My board looks to be the C32 Dual port multifunction cnc board.

10
General Mach Discussion / Re: How do you change motor direction.
« on: December 20, 2012, 01:54:00 PM »
  New info:
I think the correct name of the board is: CNC 4 PC
I also know the pin out need to be checked on the Z axis.
 

Pages: 1 2 »