1
General Mach Discussion / Re: CV and 3 axis
« on: April 17, 2012, 03:54:15 PM »
Hi Russ,
Thank you for the reply sir. I am generating G-Code by using MasterCam X5 with a very stripped down post processor...lathe setting disabled. I will try checking the initializing string and possibly post the code as you recommended.
Thank you for the reply sir. I am generating G-Code by using MasterCam X5 with a very stripped down post processor...lathe setting disabled. I will try checking the initializing string and possibly post the code as you recommended.