Messages

1

Third party software and hardware support forums. / Re: CNC3040 intermittent axis movements

« on: April 07, 2012, 01:12:26 PM »

If you want to resolved problem, just change YOOCNC card by this one :

I've have exactly same problem as you ith my new CNC3040 from amonstar after one week ... only run 5 hours when Z axis becomes crazy !!!

See link below : http://shop.ebay.fr/i.html?LH_TitleDesc=0&_sacat=See-All-Categories&LH_PrefLoc=2&cmd=Blend&_nkw=5+Axis+CNC+Breakout+Board+For+Stepper+Driver+Controller&cmd=Blend

PLUG AND PLAY with all CNC from AMONSTAR ! Best quality and many option with it !!!

D.

2

General Mach Discussion / Re: Breakout Board

« on: April 07, 2012, 04:00:49 AM »

I've have exactly same problem as you ith my new CNC3040 from amonstar after one week ... only run 5 hours when Z axis becomes crazy !!!

Idecide to look at everything and after complete cheking i saw that YOOCNC X4JKB card send wrong code to Z axis. So i decide to buy new parrallele card for CNC.

I buy 5 Axis CNC Breakout Board For Stepper Driver Controller. Runs PERFECT !!!

See link below : http://shop.ebay.fr/i.html?LH_TitleDesc=0&_sacat=See-All-Categories&LH_PrefLoc=2&cmd=Blend&_nkw=5+Axis+CNC+Breakout+Board+For+Stepper+Driver+Controller&cmd=Blend

PLUG AND PLAY with all CNC from AMONSTAR ! Nest quality and many option with it !!!

Excuses me for my english (I am french)

D.