Messages

1

G-Code, CAD, and CAM discussions / Cutting a tapered slot ?

« on: September 30, 2014, 06:41:57 PM »

Hi


             I want to cut a slot about 3 inches long I want the cutter to start at 0 depth the surface of the wood and as it feeds have it .500 deep at the end of the slot what would the proper way to do this using cambam and mach 3 ?




                                                                                              Thanks
                                                                                               Gary

2

VB and the development of wizards / Digitize Light

« on: March 18, 2014, 10:54:59 AM »

How hard is it to move the digitize led light from the diagnostic page to the program run page to make sure my probe is functioning properly. I'm running mach 3 version  R3.043.066 ?

                      Thanks
                       Gary

3

General Mach Discussion / Re: Did a litograpgh on pvc pipe something is wrong

« on: February 05, 2013, 11:33:27 AM »

here is the xml

4

General Mach Discussion / Re: Did a litograpgh on pvc pipe something is wrong

« on: February 05, 2013, 10:08:26 AM »

I'm not sure what settings to use in mach 3 to show the display of the rotary work that I'm trying to do

5

General Mach Discussion / Re: Did a litograpgh on pvc pipe something is wrong

« on: February 04, 2013, 07:48:44 PM »

I also should have stated that I cut this on a axis indexer

6

General Mach Discussion / Did a litograpgh on pvc pipe something is wrong

« on: February 04, 2013, 06:20:56 PM »

I created a lithograph in photovcarve and then used cncwrapper to create the file when I cut the piece the letting came out backwards any ideas what I did wrong ? Thanks Gary

7

General Mach Discussion / Re: Mach 3 showing a rotary file

« on: February 02, 2013, 06:58:28 PM »

I dont see that listing there is under another name ?

8

General Mach Discussion / Mach 3 showing a rotary file

« on: February 02, 2013, 10:04:10 AM »

  I make my programs up in cambam then process through cncwrapper but when I  run it through mach 3 all I see is a single line moving back and forth in y movement shouldn't I see the round object in the window if so what do the settings have to be in mach 3 in order to see the view I want? Thanks Gary

9

General Mach Discussion / Having problems getting motor stepping for A axis

« on: January 15, 2013, 10:39:11 AM »

This is the setup I have a 200step motor 1/8 turn I have a 40 tooth pulley and a ten tooth pulley I have the stepper driver set to 1/16 step if that matters. I tried to do the math but I must be doing something wrong I came up with 177.7777 If I plug that number in to
mach 3 and tell the machine to go g0 a360 the chuck will make several revolutions what am I doing wrong. Thanks for any help Gary

10

General Mach Discussion / 4th axis

« on: January 07, 2013, 12:59:17 PM »

Hi

          I built a 4th axis for my cnc router I used two pulleys and a belt 4:1 ratio. My question is what would the difference be If I connected the stepper motor directly to the headstock shaft running the chuck.