Messages

1

General Mach Discussion / Re: Please help me for mach3 plugin

« on: March 19, 2013, 01:29:28 PM »

I joined in from the dig.out plc.a, and input pulse for nonstop working, only when x changes direction then goes out, be extinguished as it should in the picture.

2

General Mach Discussion / Re: Please help me for mach3 plugin

« on: March 19, 2013, 12:36:00 PM »

I think that in my plugin does not trigger properly with dig.out.take black and white image of the cross and then my whole time working laser. turn invert then nothing laser.

3

General Mach Discussion / Re: Please help me for mach3 plugin

« on: March 19, 2013, 12:16:13 PM »

When you activate the active low dobil 4V, and when the balance when we go for the max 1.5V pin8, the dog of the laser I connected to the input 0-5V ttl.jer the laser is already connected to the moshi controller, you have to connect skype and on webcam to see what is connected.
I have 2 in the computer LPT port, I tried on both the card and the same again.
If I start the act. low laser we immediately start

4

General Mach Discussion / Re: Please help me for mach3 plugin

« on: March 19, 2013, 08:31:12 AM »

http://tinypic.com/view.php?pic=ezlnp3&s=6

5

General Mach Discussion / Please help me for mach3 plugin

« on: March 19, 2013, 08:30:06 AM »

Dear
I need help with the impact / engraving plugin for my laser.
I connect pin 8 to port 1 on dig.out. (Not a problem ack.low)
But when I upload a file in plugin laser non-stop working, does not draw a picture.
X-axis motor is in 157step 4500mm/min.25khz
please if anyone has teamviewer, knowing that you can set this up, let me know by mail juumlaa@gmail.com.

6

G-Code, CAD, and CAM discussions / Please help me

« on: March 06, 2012, 05:59:09 AM »

Dear
I have small mashine with mach3 ,and this maschine milling the wood.Maschine milling the wood 2 monath ok,and now i have proble.when mascine milling wood one time a dont have good line,i have one line 0.1 mm ticknes,on one time
in all picture,and a have a quastion how to is ponit to ponit for milling the wood.

Please help me about problem with stripe in picture.

My knife is 0.3mm and step power is 0.12mm

best regards