Messages

1

General Mach Discussion / Re: driver test does not open

« on: February 26, 2012, 01:46:11 PM »

OK, Guys ,Thanks . I'll let you know .
Bern

2

General Mach Discussion / Re: driver test does not open

« on: February 26, 2012, 09:51:22 AM »

 Tweakie
I think that is my next step on my way to CNCing  . So let you know when I figure that out .
 Thanks Bern

3

General Mach Discussion / Re: driver test does not open

« on: February 26, 2012, 09:17:26 AM »

OK ,redownloaded . I think it isn't asking where to save . So it just saves to my lap top . Now when I click on it , it opens and installs on lap top including the port driver . so when I send to the thumb drive I don't get the installers for my CNC pc . Does this sound like something or what. This was my first worm out of the can,the reason I looked for the driver test in the first place . So what I 'm trying to say is I do not get any movement at all . This made me think about parrallel port not talking to gecko controller ect. Thanks Bern

4

General Mach Discussion / Re: driver test does not open

« on: February 24, 2012, 01:08:29 PM »

Hood,  It was a used pc that was wiped clean and not been online since. Well maybe , but only when it was demo ed to me. How can I tell if 32 or 64bit ? Bern

5

General Mach Discussion / Re: driver test does not open

« on: February 24, 2012, 09:51:18 AM »

Thanks Hood, Yes I am . The hour glass shows up for a split sec ,then nothing . There is no .exe, just an icon before the word driver test .

6

General Mach Discussion / driver test does not open

« on: February 23, 2012, 02:25:39 PM »

I use windows xp pro. I cannot open the driver test window. I downloaded on lap top and transfered to CNC computer {pc} . It will not open on either . Can anyone help . Thanks Bern  PS be gentle Im pretty much a vidiot.