1
VB and the development of wizards / Re: Controlling a stepper motor from VB
« on: February 20, 2012, 10:30:03 AM »Start by reading about writing a windoze kernel driver. (good luck!)
Ian
Hi, I know it's an old topic, but i'm thinking about the same.
I saw there is a SDK but I was wondering if it is maybe possible to make a vb plugin/application for mach3 / or an application that uses the library's of mach 3 to control the parallel port
with just 6 buttons
+x,+y,+z
-x,-y,-z
Is this possible?
Thnx