Messages

1

General Mach Discussion / Re: Editing M3 & M4 command to add delay?

« on: March 28, 2013, 06:14:12 PM »

yes, I think it works for others as well but I know I am not the only one that it doesnt work for. 

    I think I will just have to spend 15 minutes seeing how to change the post processor in vectric so that it adds the delay there every time.

2

General Mach Discussion / Re: Editing M3 & M4 command to add delay?

« on: March 28, 2013, 05:58:29 PM »

I've known that but it doesnt seem to work for me.  I set up a delay but my values are ignored.   I either have to put a pause in the code or I move the spindle to a far corner to give it time to get going.

    Not sure if it is an issue with the ethernet smoothstepper that this doesnt happen for me but adding a delay in mach3 isnt working.