Hello Guest it is March 28, 2024, 05:44:15 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hdoug5

Pages: 1 2 »
1
Brains Development / Re: ModIO THC success
« on: March 21, 2013, 05:50:39 PM »
how do i open your file?

2
Show"N"Tell ( Your Machines) / Re: China HF-start plasma CNC design!
« on: February 13, 2013, 11:46:31 AM »
I tried this on my cut50D and still have HF interference, must have some wires touching inside of case but using it free hand the plasma works great.  any suggestions ?

3
Tangent Corner / plasma locks steppers when turned on
« on: August 25, 2012, 12:19:48 PM »
Hi everyone
got a lil problem with my plasma cutter and steppers, I have a chinese plasma cutter a colossal tech 50D good lil machine .
and i have my router / plasma table cnc machine when working with the router everything works fine but when i put the torch on the z bracket and turn the plasma cutter on my steppers make a weird noise like a buzzing sound and they wont move. I ve tried moving the plasma cutter away from the table even moved the electronics but still does it
The machine has two grounds one for the material and one frame ground the frame ground has no effect on the operation either hooked up or not
if you know of possible solutions im all ears and willing to try anything to get this working
Thanks in advance
Doug

4
LazyCam (Beta) / Re: lc cant find mach3 running
« on: July 23, 2012, 08:05:23 AM »
Hi Rich
yes i have the manuals im running xp, the thing is up til yesterday LC would post the G codes and the LC i have came with mach3
ive been running a lot of nc files lately and just not sure if that has anything to do with iti can open the roadrunner file and decrease the size by 10% then post it and get the same error message i dont have the pro version yet i guess that will be the next thing on my bucket list
thank you for responding :)

5
LazyCam (Beta) / lc cant find mach3 running
« on: July 22, 2012, 04:02:53 PM »
i can put a dxf file in lazy cam and when i go to post it i get an error message saying lazycam cannot find mach3 running when in fact it is
i really need a book, lazy cam for dummies that is fully illustrated... ha ha.  but really if anyone had this happen could you please let me know how to fix it

6
hi
the people that sold me the tb6560 took it back as defective and are replacing it with a new one
i also bought a quickcnc driver board works pretty good so far

7
heyyy thanks Tweeky
i will check that and see but isnt it ironic that two pc's would have the same problem ?
this just all of a sudden happened it was working great a week or so ago themotor will make a growling sound then take off in another direction (I think its haunted lol)

8
ive changed drivers ive changed motors ive changed pc's nothing helps i did the swap with x&y axis and still the same problem with X being on Y's slot it will run straight for a few seconds but if it has to stop and do a lil jog it will reverse direction but the counter continues going as it was  like telling it to go 20 inches then stop to cut hole it will start ok but then it changes direction when it should be going as it started and the counter keeps going up
i hope this helps
Doug

9
ok did the swap i do believe i have a hardware issue with my new controller, thank you for your help on this i really apreciate it
i'll let you know if a new controller fixes it

10
ok i found this in one of the xml folders  i believe this is the last updated one on here i hope this helps

Pages: 1 2 »