1
FAQs / Re: which way is xy as i stand at my mill?
« on: March 20, 2012, 09:54:26 AM »
Tks for the replies. Something I should have added at the beginning, I cannot change where the start point is. I zero x,y,z for lower left and start the cycle and Mach 3 runs it as if it was in the upper right. I’m using Cambam for my gcode, so I tried different starting point in the drawing and different orientation of the drawing. It always runs from the upper right.
2nd question, I have the Abnormal condition LED on “IJ mode is incremental” is this due to the .002 backlash I have set in Mach 3?
2nd question, I have the Abnormal condition LED on “IJ mode is incremental” is this due to the .002 backlash I have set in Mach 3?