1
General Mach Discussion / Update on progress~
« on: February 24, 2012, 07:11:32 AM »
Back from Texas, the folks a CandCNC are really nice, it was a pleasure meeting them. I have the table partially finished now, I have my home switches installed and a z axis limit switch to keep it from damaging the head again, and they work! z axis hits a limit, it stops the machine, click reset and override limit and you can manually back it off the limit, if you click go home, the gantry goes - to home switch x and y then backs up +.500, i will tune that in closer as this table does not have a full 8 ft of cutting travel for y axis, ok it does, but the torch head has to be past the slats to get that length
anyhow I'm pretty happy about this! I have some ways to go yet in setup and have run into another couple issues trying to cut a file, but I think it is for another post
I just wanted to say thank you to everyone as every bit of information posted here and private messages has helped me in more ways than you can imagine!
TOm
anyhow I'm pretty happy about this! I have some ways to go yet in setup and have run into another couple issues trying to cut a file, but I think it is for another post
I just wanted to say thank you to everyone as every bit of information posted here and private messages has helped me in more ways than you can imagine!
TOm