Messages

1

General Mach Discussion / Licensing

« on: March 18, 2012, 10:16:39 AM »

Hello, I am in the process of waiting for new machine to arrive and would like to know procedure for transfering Mach 3 license to new machine?  Anyone have answer?  Thanks---Jim

2

FAQs / Mach 3 setup

« on: January 12, 2012, 05:08:33 PM »

Hello, I am upgrading from Mach 2 to Mach 3 and I do seem to be abel to get Mach 3 up and running right.  I have the motors turning and set the steps up and seem to have axis moving, but when I load job and try and cut, it seem that the x axis want to start job and then start to run off table.  Could anyone help me with this?  My Mach 2 ran perfect.  Any answers.  Thanks