Messages

1

General Mach Discussion / Re: first help

« on: December 17, 2011, 02:00:02 AM »

Hi

I remove and install again the maxh3 software and the driver test show ok:

link deleted by Stirling

Can you please sea my XML file and tell me what setting is incorrect? why i don't have motor rotation?

2

General Mach Discussion / first help

« on: December 17, 2011, 01:11:16 AM »

Ho to all

I am new in this forum and mach3 software.
It is very good software but i am new and need your help.
I saw some tutorial video but i can't run my step motor.
Can you please help me for below questions:

1- When i test the drive it show me below error :

link deleted by Stirling

when i click on special driver it show me below error :

link deleted by Stirling

what should i do ?

2-  setup my pin and port also please sea below file and tell me does it true or not?

link deleted by Stirling



I am wait for your reply.


Thank you