Messages

1

G-Code, CAD, and CAM discussions / Re: Need Help

« on: December 17, 2011, 01:32:43 PM »

Thanks for all the help i will see what i can figure out.

2

G-Code, CAD, and CAM discussions / Re: Need Help

« on: December 17, 2011, 01:10:09 PM »

It a lathe boring operation. I forgot to mention that i am using mach3turn. Not sure if this helps i hope so.

3

G-Code, CAD, and CAM discussions / Re: Need Help

« on: December 17, 2011, 12:44:23 PM »

Sorry about that. Here is a DXF 2007

4

G-Code, CAD, and CAM discussions / Re: Need Help

« on: December 17, 2011, 12:15:04 PM »

Here is that CAD file. Again very new to all this so thanks for your help.

5

G-Code, CAD, and CAM discussions / Need Help

« on: December 16, 2011, 09:31:28 PM »

Hello new here. Trying to use the CAD drawing below and get it into mach 3. Its a boring operation and mach and lazy cam do not read them properly and i am having trouble generating G-code that ends up looking like this when it finally gets to mach 3. The red are my roughing cuts to remove materiel the yellow is my roughing of my profile and the green is my final pass. All help is much appreciated.