Hello Guest it is April 24, 2024, 05:59:28 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mdfmk

Pages: 1
1
General Mach Discussion / Re: dxf file import question
« on: March 18, 2007, 02:22:50 PM »
I should prbably start a new thread but my question deals with this subject.
When  you import your dxf file, can you import the g coding in inches? or in Mach 3 is there a conversion wizard to convert metric to inches?

Pages: 1