Hello Guest it is March 29, 2024, 10:12:54 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JBS4WD

Pages: 1
1
LazyCam (Beta) / Re: To Lazycam or Not to Lazycam
« on: December 13, 2011, 12:09:42 AM »
Thanks Rich. I have decided to go with CAMBAM.

Cheers
JOHN

2
LazyCam (Beta) / To Lazycam or Not to Lazycam
« on: December 12, 2011, 06:02:33 PM »
I just read that Lazy cam will stay as Beta. And not develop anymore. Is this true?
If it is true and since I am starting out I would like to peoples opinions on what alternative I should use. I dont want to pay for something that will quickly be outdated. I like lazycam but dont want to waiste my hard earned $$.
Any info and direction would be appreciated.

Ceers
JOHN

3
FAQs / Re: Incomplete Gcode load
« on: December 05, 2011, 10:10:02 PM »
Rich
Thanks for your help. I now have the license and all is good. Now for the real brain work to start building projects.

JOHN

4
FAQs / Re: Incomplete Gcode load
« on: December 05, 2011, 05:43:37 PM »
Ok it looks like because I am just using the demo version at the moment that is my problem.  I just thought that a simple  j wouldnt have so many lines. Thanks Rich. I will have to get the licence for it.

Cheers
JOHN

5
FAQs / Re: Incomplete Gcode load
« on: December 05, 2011, 05:23:07 PM »
Rich

I used LAzy cam to make the J. Used the drag feature. I have added the Lcam file.
Cheers
JOHN

6
FAQs / Re: Incomplete Gcode load
« on: December 05, 2011, 04:14:08 PM »
Rich
As requested
Thanks
JOHN

7
FAQs / Re: Incomplete Gcode load
« on: December 05, 2011, 05:44:26 AM »
I tried them Thanks they worked fine.  But I just tried doing a J and there was only 250 lines and only half the J was there in mach3.
Would it be I am missing something in the chain set up or something like that?
Been at it for ages and at a loss. I fresh mind is needed I think lol

Cheers
JOHN

8
FAQs / Incomplete Gcode load
« on: December 04, 2011, 11:22:37 PM »
Hi
I am new to this area but know software however am at a loss with this.
I make a file in Lazycame to route  'JB' I do everything that is outlined in the videos and manuals, however when I load the Gcade into Mach3 only part of the lettering is loaded.
Has anyoneone elese had this problem and does anyone know what I am doing wrong?

Cheers
JOHN

Pages: 1