Messages

1

General Mach Discussion / Re: Toonewbie or not toonewbie

« on: November 27, 2011, 11:01:51 PM »

I found a poster who had a similar problem with the newest version so I tried an older version and it seems to work for me on my 30 dollar Kijiji Pentium 4.

2

Mach3 and G-Rex / Re: reset button locked

« on: November 27, 2011, 08:57:14 PM »

Perhaps I will try an older version on my xp machine.

3

Mach3 and G-Rex / Re: reset button locked

« on: November 27, 2011, 08:56:42 PM »

same here.   It work ok on my windows 7 64bit machine but not on my working xp machine.  I am locked out of running live but can run a program offline.

4

General Mach Discussion / Re: Reset

« on: November 27, 2011, 08:24:45 PM »

To me clearer.

I can't reset E-Stop unless I switch to offline.

5

General Mach Discussion / Toonewbie or not toonewbie

« on: November 27, 2011, 07:57:27 PM »

I have Mach3 loaded on my Windows 7 machine and on my P4.  When I run on my 7 machine, I can run in live mode which is uselss as it does not have a parallel port.  I can't seem to run in live mode at all on my p4.   

I am trying to measure signal changes on some pins but can't get output. Any ideas.

thanks