Hello Guest it is March 29, 2024, 09:25:05 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - valletef

Pages: 1
1
General Mach Discussion / Re: Crazies Motors !!!... Please Help!!!
« on: December 19, 2011, 07:43:00 PM »
Hi Brett... thank you !

I just attached it.... I hope you both can help me!.

Thanks!.

Frank

2
General Mach Discussion / Re: Crazies Motors !!!... Please Help!!!
« on: December 19, 2011, 07:37:18 PM »
Hi Hood.... is the best that I can do.... thats ok?

Thanks..

Frank


3
General Mach Discussion / Re: Crazies Motors !!!... Please Help!!!
« on: December 19, 2011, 06:58:29 PM »
Are you talking about the 540BVFD, from GECKO?.   Thats the one that I'm using to open my mill.

If is the information that you are asking for.. how can I find for you reading?

Thanks for your interest in my problem... my friend!

Frank
I'm sorry for my english.....

4
General Mach Discussion / Crazies Motors !!!... Please Help!!!
« on: December 19, 2011, 06:33:57 PM »
Extreme Newbie here.  I have a  homemade CNC and it was running fine for a month.
Now, I have a problem with two of my motors (Y and Z axis).   When I specify an UP move
It go UP or DOWN, randomly.  Same if I specify a DOWN move.

I reinstalled the MACH3... but same.

Both Stepper Motors are HT23-280-8 from Robotix.
The third one (X axis) is a HT23-400-8.
All in parallel.
Gecko540.
Mach3.

Would one of you kind souls please enlighten me?.

Thanks.

Frank

Pages: 1