1
General Mach Discussion / Re: X AXIS NOT WORKING
« on: November 28, 2011, 06:29:37 PM »
I honestly did not have a clue as to what these programs costed before I started with this. The reason I bought the miller in the first place was to make small mode airplane parts that were expensive to by in Carbon. Now it seems that (disregarding the learning I am getting) this is a very expensive way to go. I am stubborn so now I want to learn, that is why I have not thrown it out. It is bought on eBay and after checking prices there for same equipped millers this was in the normal range with motors frame and controller.