Hello Guest it is May 10, 2021, 12:07:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - zachm

Pages: 1
1
Figured out the solution. It had nothing to do with Gcode but with one of the motors not functioning right. Please ignore this post!!!!!

2
G-Code, CAD, and CAM discussions / Gcode tool path not cutting properly
« on: January 13, 2012, 12:41:59 PM »
Can someone look at this GCode and see if they notice anything wrong with it? The pockets were created in CamBam and then produced the GCode. I run the code in a similator and the tool path is correct. I pull it into Mach3 and the tool path looks correct but when it runs. The first two pockets are correct then the next 6 are smaller and then the next pocket the tool runs out of control.

Any help would be great!

Thank you,

Zach
zach@pelicansuperstore.com

3
General Mach Discussion / Need onsite training in Austin Texas
« on: November 08, 2011, 02:53:16 PM »
I'm looking for a local individual or company in central Texas to do some onsite training for Mach3 and LazyCam.

Thank you,

Zach

zach@pelicansuperstore.com

Pages: 1