1
General Mach Discussion / help with home postion please
« on: January 29, 2012, 12:56:49 AM »
hello all. I am new to mach and am looking for some help. I currently use vcarve with mach. I wish to cut on the opposite end of the table then return to the home position after the program ends. I am aware that g28 will work but is there a way to do this automatically. I currently us an offset of x= - 48 to cut on the the corner of the table i wish to use, should this be done in vcarve instead of mach? any info would be appreciated.
thank you shad
thank you shad