Hello Guest it is April 23, 2024, 10:30:04 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - conceptmachine

Pages: 1
1
General Mach Discussion / featurecam post
« on: April 18, 2007, 02:23:15 PM »
I just purchased the ascension 1000 upgrade for my shopbot and i'm going to use mach3.I have featurecam but no post processor for mach3,does anyone have a post or will another one work?
   Thanks,
    Shawn

Pages: 1