Hello Guest it is August 13, 2020, 04:44:22 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - pontiacg5

Pages: 1
1
General Mach Discussion / Re: Mach 3 axis moving after exit/estop
« on: May 06, 2013, 04:24:30 PM »
It would seem you need to explain to yourself why you locked your own topic without any explanation to yourself ;)

What it sounds like is you have something in windows that is trying to use the parallel port, when Mach is running it is in control and stopping it moving bit as soon as you shut Mach down then the device/software is able to communicate and thus your motor moves.

Hood




I certainly wouldn't lock my own post, how silly would that be? Besides, I got a nice e-mail saying it was locked by a "stirling."

I guess if there's any question if it's a pirate license you just lock first and answer later? If you want to see my license just ask...

But that's besides the point. I seem to have the problem fixed. There was some setting in mach that fixed the problem, something like transformer on in e-stop? That fixed the runaway problem, though it still stutters hard when closing mach 3 unless you remember to turn power off to the drives first.

rcaffin, I believe this machine has relays on the outputs to kill the drives in a situation like that. The BoB brings the drives up, and if it ever looses power it clicks the drive off right away. Supposed to at least...

Thanks!

2
General Mach Discussion / Mach 3 axis moving after exit/estop
« on: April 30, 2013, 02:06:24 PM »
Thanks for locking my old thread with absolutely zero explanation as to why. I really appreciate that!

My machine seems to work fine, but when I press the reset button or exit mach 3 the x axis continues moving while in e-stop mode. Clearing the software e-stop makes the x axis quit moving. Playing with the motor tuning settings seems to change how the axis moves, but it always moves when it shouldn't. It's not moving very smoothly when this happens either, grinding and making lots of heat.

Turning the x axis pins off keep mach from moving the axis, but it still runs away in e-stop mode.

Is this a hardware issue or software?


3
General Mach Discussion / Moving a mach3 install
« on: April 29, 2013, 01:45:43 PM »
Hello everyone

I have a mill set up at work to make augers, unfortunately the PC that originally ran it kicked the bucket. As old as it was a direct replacement was impossible so I went with a new PC.

Before I installed the new copy of windows I copied over the root drive of the old PC. Now I have a mach3 folder that hopefully has everything I need in it!

I've got a mach1lic.dat file, which opens as some gibberish. Is this my license file?

The mach3.exe is file version 1.0.0.1. Is this a current version? If I install the current version will the license file I have now sill work?

I don't know much about this machine, all I know for sure is that we bought the machine from a company going under. Than again, the g-code I really need to run is only like 15 lines long. I might not even have a full version for all I know. Do I need to even bother with the full version?

I just need this thing to hold out for another month or so till we can convert it over to a Baldor servo system!

Thanks for the help!

Pages: 1