Hello Guest it is March 28, 2024, 10:05:07 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mike542

Pages: 1
1
General Mach Discussion / Other interface?
« on: March 18, 2007, 02:37:51 PM »
  Hi. I finished my homebuilt cnc machine awhile back and have been using Mach 3 on a regular desktop PC with a parallel port, but  I would like to hook it up to my new Dell Laptop i'm buying. The only problem is it doesn't have a parallel port. I'm also using the 3 axis cnc pro driver board from Hobby CNC. Is there any way to use a usb port or would a expansion docking port work ( This uses the laptop's usb port and then has a parallel port, serial,etc.) Any help would be greatly appreciated. Thanks.

2
Mach3 under Vista / Mach 2 in Vista?
« on: March 11, 2007, 09:52:53 PM »
I am using Mach 2 on XP Pro to run a home built CNC machine, but I would like to switch to Vista Home Basic Is this possible to do. Any help would be appreciated.

3
General Mach Discussion / Mach 2 in Vista?
« on: March 11, 2007, 08:44:57 PM »
I am using Mach 2 on XP Pro to run a home built CNC machine, but I would like to switch to Vista Home Basic Is this possible to do. Any help would be appreciated.

Pages: 1