Hello Guest it is March 29, 2024, 05:53:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - DJNPHOTO

Pages: 1
1
General Mach Discussion / Need help ASAP
« on: March 19, 2014, 12:41:35 PM »
here goes
 I setup a job so center is in the middle of the wood. when I start and run the job it starts out ok for the 1st pass but when it gest to the 2nd pass it has move's
 over to the right little by little on each pass I am running mach 3 any help if I need to reinstall the program or just reconfigure my mach3 I just don't know how this happen it was working just fine a week before and I did nothing just turn on the computer. As you can see in the photo's that they both mover over to the right every time. My machine is a KL6090

Pages: 1