Messages

1

FAQs / Re: Mach3 does not respond to jogging or running G-code

« on: October 03, 2011, 10:45:27 AM »

Hi All
I have installed Mach and gone thru all the setup done the driver test all ok when I try and jog I get movement on my screen but no output to my breakout board any ideas?

2

General Mach Discussion / Re: Printer Port Problems

« on: October 03, 2011, 05:54:42 AM »

If you have been running in demo can you load the driver later?
I am unable to get a connection thru the LPT port