Hello Guest it is March 29, 2024, 02:23:09 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - forbesbrb

Pages: 1
1
General Mach Discussion / mach 3 and win xp pro
« on: May 06, 2019, 07:11:22 AM »
i have just load mach3 into my pc running windows xp pro and i can not get it run propery i have the correct settings as i used in my last pc but this one is not doing so. when i load my gcode it is cutting the parts like the where 1/4 the size i can't fathom this out i have been using same cnc machine the units are set to mm and the software i use is cut2d and that is set to mm the only thing that i have noticed that i have not notice before in device manager i see mach3 pulsing engine i have never seen that before??

Pages: 1