Hello Guest it is April 10, 2021, 09:33:28 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - mirek.cermak

Pages: 1
1
Yes, I had to change the interface (board).

2
General Mach Discussion / Re: Error returned from USB function FT_Write
« on: September 24, 2011, 07:36:51 PM »
I didn't explain well. When this error appears, I have to restart the PC completely, but then I lose the coordinates... I begin to cut once again and the error keeps coming you never know when and why... Sometimes it's like once a day, sometimes it's like every hour. I lose so much time.....

Thx for any suggestion.

3
General Mach Discussion / Error returned from USB function FT_Write
« on: September 24, 2011, 02:16:08 AM »
Out of the blue, my smoothstepper quit responding and a pop up error
message says:
Error returned from USB function FT_Write
Error: FTDI USB Driver Error
Error=FT_IO_ERROR
Bytes requested: 192
Bytes written: 0

I changed the driver and plugin for SmoothStepoperUSBDriver2.0802 and Plug
in SmoothStepper_v17bd but I still get the same error after a whole.
I'm using win7 and never had this problem before.
Any suggestion?
Thanks,
Miros

Pages: 1