Messages

1

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: September 23, 2011, 02:43:16 PM »

I am receiving a VB failure prompt on Mach3 when I am trying to mill a pocket cut what am I doing wrong?  I also notice that when I post from LazyCam in my info it is showing that it is being posted but it does show me on the screen that it has been posted to Mach3--  You replied that I might have a bad marco--how do Ii find this out and how do I fix it?

2

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: September 22, 2011, 04:21:43 PM »

Whee would like look for this???  i only get this error when I try to do  pocketing, if I am doing a contour it works fine.

3

General Mach Discussion / Re: Welcome to the official Mach 2/3/4 support forum.

« on: September 22, 2011, 11:45:54 AM »

I am receiving a VB failure prompt on Mach3 when I am trying to mill a pocket cut –what am I doing wrong?  I also notice that when I post from LazyCam in my info it is showing that it is being posted but it does show me on the screen that it has been posted to Mach3