Hello Guest it is April 16, 2024, 08:48:25 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - shucks

Pages: 1
1
General Mach Discussion / Re: over sized pattern in MACH
« on: September 09, 2011, 10:18:58 AM »
thanks, we'll check those.

2
General Mach Discussion / over sized pattern in MACH
« on: September 08, 2011, 06:11:41 PM »
We are new to this. Sorry if this is a stupid question!

Why are we getting our pattern imported from sheet cam into MACH roughly over twice the size of the original pattern? We are using this software for a plasma table. Help would be appreciated

Pages: 1