Messages

1

General Mach Discussion / Torchmate/Mach3

« on: September 23, 2011, 09:44:16 PM »

I am new to M3 and i am setting up a plasma table for work. I use Torchmate at home on my machine. My question is in torchmate it has the option to turn on the torch any time it sees G1,G2,G3 and off for any other code. this makes writing g code very simple. Does Mach3 have this option?    Thanks, Rex

2

LazyCam (Beta) / Re: LazyCam will not post Gcode anywhere

« on: September 15, 2011, 09:50:23 AM »

Thank you, I was under the impression that sense LC was in with M3 that the M3 license was good for both.

3

LazyCam (Beta) / Re: LazyCam will not post Gcode anywhere

« on: September 14, 2011, 08:22:49 PM »

Hi Still having problems, i re installed mach 3, had the vendor send me a new copy of the license and dropped it in M3 folder ? (is Mach3 license also for LazyCam ) ?  if so it is not showing up in LC it still says Prodemo   on the off set button and under the help menu my name is not there but it is in Mach3. i installed everything at the same time. is there somewhere else that the license goes?    Thanks Rex

4

LazyCam (Beta) / Re: LazyCam will not post Gcode anywhere

« on: September 09, 2011, 10:22:36 PM »

Thank you i will

5

LazyCam (Beta) / Re: LazyCam will not post Gcode anywhere

« on: September 09, 2011, 09:02:14 PM »

Windows XP

6

LazyCam (Beta) / Re: LazyCam will not post Gcode anywhere

« on: September 09, 2011, 08:56:55 PM »

Thanks for the reply, lcam was installed at the time m3 was . licenses was sent on a disk by it self with instructions to drag and drop in the M3 folder. it is there i checked. i have tried this on 3 different computers all with the same thing happening or should i say not happening

7

LazyCam (Beta) / LazyCam will not post Gcode anywhere

« on: September 09, 2011, 03:50:37 PM »

Yes this is a licensed copy, if i in port a simple square or any shape and post, it will go but if i pocket or offset it will not post.Yes I deleted the original shape. i am getting my a$$ chewed out by my boss for this. he wants to know why he bought your program if it does not work? and yes i do load lazycam from mach3. it wont post to a folder either.

                                                                                                                                                                                                                    Thanks Rex