Hello Guest it is March 28, 2024, 08:04:11 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - rival

Pages: 1
1
General Mach Discussion / Re: Problem with motor tuning
« on: August 31, 2011, 05:53:32 AM »
Hood

The steps per mm work out perfectly in terms of movement on the table.
Oriental motors with 7.2 gearbox 36 tooth pinion on module 1 rack.

Thinking it might be a computer issue .

Andrew

2
General Mach Discussion / Re: Problem with motor tuning
« on: August 31, 2011, 03:10:40 AM »
Hi, File as attached

3
General Mach Discussion / Re: Problem with motor tuning
« on: August 30, 2011, 08:33:26 PM »
HI, The frequency is pretty stable hovers pretty much around the 35000 I have set.
The Time in int flickers around 3.8 - 4.5 occasionally jumping to 8-9 , Is that bad.

Andrew

4
General Mach Discussion / Re: Problem with motor tuning
« on: August 30, 2011, 06:29:50 AM »
Hi ,

Have tried 3 different kernel speeds, all exhibit the same discrepency between motor tuning and actual running of the motors under jogging or running code.
Tried just about every pulse width variation.

Has been suggested on the mechmate forum( Thats what i am building ) , that the motor tuning dialog uses different software to run than the rest of the program. That would explain the difference, but not sure if that is true or not.

Going to re-double check my wires / earthing again.

Any other suggestions more than welcome.

Andrew

5
General Mach Discussion / Problem with motor tuning
« on: August 30, 2011, 02:56:43 AM »
Hi,

Hoping the forum can help with a problem.
I am configuring my machine at present and am having issues with motor control.
I have great success tuning my motors under the tuning dialog box, got steps per mm correct etc. get good smooth running accel on all axis.
But when I save and exit the motor tuning dialog box, the motors do not perform the same at all.
When trying to jog or run code they act all jerky/stall move roughly etc.

If I slow the motors right down under the tuning dialog, then save exit. The machine settles down a bit, but still runs rough in comparison to the setting in the tuning dialog.

Any suggestions.

Oriental motors 7.2 gearbox
gecko 203's
running 56v
mach3

have checked all wiring

mach 3 pulse test all good.

Any help much appreciated. Been trying to resolve this for days.

Andrew

Pages: 1