Messages

1

LazyCam (Beta) / Re: Start engraving as drill and angle

« on: August 22, 2011, 05:35:13 AM »

You mean about this settings?
I can change it and get result, but if I open it again then I see old value

2

LazyCam (Beta) / Re: Start engraving as drill and angle

« on: August 21, 2011, 09:43:15 AM »

Here you have file from cdr9, plt file, lc file and .tap

"1" in name is with cut deph -1mm specially look at inside of letter "A".
"10" in name  is with cut deph -10mm. here all is OK 

3

LazyCam (Beta) / Re: Start engraving as drill and angle

« on: August 21, 2011, 08:20:18 AM »

Thanks for your reaply.
No, I have only one pass (in tool I set max cut as 10, and in real I take only 1mm so it is ok).
My problem is why tool go into material under angle (slant)? why not upright?- that I need. Look again at red arrow in above image

I see something else, if I use only offset then toll go upright, but if i add poket then each entrance into material I have with slant

4

LazyCam (Beta) / Start engraving as drill and angle

« on: August 21, 2011, 05:04:10 AM »

Because it's my first post... hello, and sorry for my English

I have little problem, I use offset and pocket function for letter (import from corel). In g-code i see that start of engraving is not as drill but under angle.
How to change it for drill, or engrave again this place?