Messages

1

General Mach Discussion / Axe position number not in bold

« on: December 28, 2011, 06:21:28 AM »

Hi:

After making some changes I have seen at the main screen the numbers about an axe position aren´t in bold characters, like the other ones. What is its meaning?

Thanks

2

LazyCam (Beta) / Re: Foam 2D with X Y Z A hot wire

« on: October 13, 2011, 12:59:06 PM »

In pin assignments screen, Z line in blank, and what was there, write it in B line. Now you´ll have B axis and it will be able to slave to Y axis

3

LazyCam (Beta) / Re: Foam 2D with X Y Z A hot wire

« on: August 18, 2011, 03:22:40 AM »

Thank you very much. I've got it as you said, BR549 

4

LazyCam (Beta) / Re: Foam 2D with X Y Z A hot wire

« on: August 16, 2011, 06:32:24 PM »

Might want to reconsider your axis assignments it would make it easier to deal with.  X/a Y/b

(;-) tp

My board has only X,Y,Z,A

5

LazyCam (Beta) / Foam 2D with X Y Z A hot wire

« on: August 16, 2011, 07:58:57 AM »

Hi:

My machine is X horiz right, Y vert right, Z vert left and A horiz left. I don´t have B, C, etc. Usually I cut wings in 3D with Profili soft, which generates GCodes I cut via Mach3.

Sometimes I need to cut 2D profils designed in Acad in dxf. Lazy Cam only generates GCode with X and Y axes (with default pre processors) so in Mach3 I define A axis (horiz left) as salve of X (horiz right) but I can´t define Z (vert left) as slave of Y (vert right) because Z is main axe. I think I´m right.

Is it possible with Lazycam, generating a GCode with XYZA axis? X and A would be identical, and the same with Y and Z. ¿Perhaps with a foam 2D specific post processor?.

Thanks.

Edu