Hello Guest it is March 29, 2024, 08:30:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ashleigh

Pages: 1
1
General Mach Discussion / Re: Coming out of jog error
« on: August 08, 2011, 06:50:04 PM »
please dumb some of this info down for me as my tech knowledge is so very limited.....

2
General Mach Discussion / Re: New Hermes Vanguard 3400
« on: August 08, 2011, 06:48:39 PM »
I cant seem to get the machine to stay at a "start" point when programed.....my boss had a template made so i need to get it to start engraving at a certain point and it seems to want to go to the upper left to start every time....

3
General Mach Discussion / New Hermes Vanguard 3400
« on: August 08, 2011, 06:09:51 PM »
Looking for Help,
    My company has recently purchased a New Hermes Vanguard 3400 Engraving machine…..and I have been tasked with the job of figuring out how to run it….unfortunately I am not the most “tech” savvy person.;…and I’ve hit a “brick” wall so to speak……if there is anyone out there who would be willing to give me some help I’d REALLY appreciate it….I don’t usually become this stumped but I don’t know where else to turn…..

Aggravated with engraving in Seattle :P
206-767-4144

4
Looking for Help,
    My company has recently purchased a New Hermes Vanguard 3400 Engraving machine…..and I have been tasked with the job of figuring out how to run it….unfortunately I am not the most “tech” savvy person.;…and I’ve hit a “brick” wall so to speak……if there is anyone out there who would be willing to give me some help I’d REALLY appreciate it….I don’t usually become this stumped but I don’t know where else to turn…..

Aggravated with engraving in Seattle
206-767-4144

Pages: 1