Messages

1

General Mach Discussion / Re: spindle pwm pin assignment other then #2-#9?

« on: August 05, 2011, 03:15:44 AM »

thanks for your comment

2

General Mach Discussion / spindle pwm pin assignment other then #2-#9?

« on: July 29, 2011, 12:38:17 PM »

Can I use pin #1, #14, #16 or #17 for Spindle PWM output properly at 1KHz base Freq.?
pins #2-#9 are high speed output but I couldn't find any information about timing of other outputs of mach3 in the documents.

Thanks...