Messages

1

Mach SDK plugin questions and answers. / Feed rate over ride switch

« on: August 02, 2011, 06:08:39 PM »

G,day to all
I am new to this forum and am not sure to ask this question here or not, but here goes.

I have extensively used Fanuc controlled machines and the most useful control knob is the FEED RATE over ride. It allows for easy tool approach at a rate you can control with the knob.
I see Mach3 has onscreen sliders with the same function.

Can you get a USB hardware switch to control these sliders

Regards

2

Feature Requests / Re: conditional execution

« on: August 02, 2011, 05:59:04 PM »

Every other 'dialect' of gcode supports these functions, and to be taken seriously in the future Mach needs to support at least the obvious capabilities - 'IF-THEN-ELSE' and 'DO WHILE' along with the logical comparison functions (GT, GE, LT, LE, NE, EQ).

Yes please