Hello Guest it is October 25, 2020, 09:36:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - scotsman

Pages: 1
Tangent Corner / Re: Zenbot owners
« on: July 20, 2011, 05:40:33 AM »
Hi Mikee

are you saying cam/bam is difficult and not user friendly, one of the replies i have had recommended Vectric for simple 2D and 3D
it appears that for my simple needs scale model making (trucks in wood) it appears straight forward but things always appear that way
until you try it in the physical world,  i need to research a bit more i am not sure if this package has to interface with mach3 or similar are you familiar
with this package?

Thank you for your advice.
 Regards scotsman

Tangent Corner / Re: Zenbot owners
« on: July 19, 2011, 09:51:16 PM »
Hi Mikee

thanks for your reply You are correct I feel like a proper "eegit", theres such a lot to learn so I just have to work through it however a book "cnc for eegits" would help.

Thanks and regards Scotsman

Tangent Corner / Zenbot owners
« on: July 18, 2011, 03:41:38 AM »
Hi all
does any one have any first hand  experience in the set up of this cnc router, had mine a couple of months and
not turned a wheel, dont know where to start.


Pages: 1