1
One on one phone support. / Re: Mach3 upgrade from R3.033 to 3.043.022 stops communication to MAXNC controller
« on: July 14, 2012, 01:53:55 PM »
OK, So this is how I made it work.
I made sure the original version installed in \MaxIII worked. I then downloaded and installed .043.062 into the MaxIII folder and not into the suggested folder Mach3.
Then, when I started the executable, it offered me both the new and old profiles. I selected the old profile and it ran! So then, once that worked, I took all the settings from the old profile and changed the default new milll profile to the older profile settings - and happily, it works!
As well, the backlash routine now works and does an excellent job. I again can hold less than a thousandth on a G3 circular cut.
Thanks for sticking with me!
I made sure the original version installed in \MaxIII worked. I then downloaded and installed .043.062 into the MaxIII folder and not into the suggested folder Mach3.
Then, when I started the executable, it offered me both the new and old profiles. I selected the old profile and it ran! So then, once that worked, I took all the settings from the old profile and changed the default new milll profile to the older profile settings - and happily, it works!
As well, the backlash routine now works and does an excellent job. I again can hold less than a thousandth on a G3 circular cut.
Thanks for sticking with me!