Hello Guest it is April 23, 2024, 03:18:29 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - drorbo

Pages: 1
1
General Mach Discussion / Re: need help
« on: June 21, 2011, 05:13:32 PM »
thanks

2
General Mach Discussion / need help
« on: June 21, 2011, 04:58:53 PM »
I have an old CNC with FANUC 0M controller dose someone knows if it can be used with the software like mach3 in order for me to be using moor M code
then the one i have.
i am using a dnc drape feed because of the small memory.
dror

Pages: 1