Hello Guest it is March 28, 2024, 05:40:44 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cb400f

Pages: 1
1
General Mach Discussion / Re: New Mill Drill conversion
« on: June 19, 2011, 12:07:01 AM »
Thanks Rich,

The ball screws are 5/8 od".  Do these seem ok?

Thanks
Curtis

2
General Mach Discussion / New Mill Drill conversion
« on: June 18, 2011, 08:14:54 PM »
Brand new to this CNC building.

Would like your input on my Mill Drill conversion.  Got some Linear actuators from work with size 23 triple stack steppers, rated at 125 oz-in.  Ball screws with 5 tpi and 10t motor pulley and 20T screw pulley with XL timing belts.

Do you think these component are adequate for use on the conversion.  Specs from the actuator show it is rated at 200lbs thrust.  Just wondering what other people are using for conversions on these mill drills.


Thanks
 

Pages: 1