Hello Guest it is March 28, 2024, 09:08:27 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Crabbyadam2002

Pages: 1
1
General Mach Discussion / Re: strange self changing z axis value
« on: July 25, 2011, 03:45:39 AM »
i can send it to you.  i tried to put it on this message, just too big.  unless there is another way

2
General Mach Discussion / strange self changing z axis value
« on: July 25, 2011, 01:07:35 AM »
im having a problem with my z axis changing its value....im cutting a guitar body, my wood is 1.75" high....the first cut is at 1.65" so it drops .1 and cuts, goes through the parameter and then goes to cut the second sweep around.  it resets itself at 1.85 evertime, however 1.85 seems to get further and further away from its last z position.  so it will not cut any deeper bc it gets further away everytime.  not sure why.   help :)  phillip

Pages: 1