Hello Guest it is March 28, 2024, 08:22:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - NavyGunner1980

Pages: 1
1
How is Spindle speed controlled? PWM ? or some other mechanism?

2
General Mach Discussion / Using a Stepper motor as a spindle motor
« on: June 01, 2011, 03:24:58 PM »
Hi I was wondering if MACh3 supports using a stepper or servo motor as a spindle motor?
My current need is for using it to cut threads on a Sherline Lathe.

do you need to purchase any plugins for this or is it built in?

Thank you for your time.

Pages: 1