Messages

1

General Mach Discussion / Re: Help Please: Computer upgrade causes no communication with controller

« on: December 21, 2019, 12:15:18 AM »

I realize this is a very old topic, but I have the same controller.

My pc disk died, and my backup is corrupt.

Any chance I could get a copy of your XML file to help me get back on the air quicker?

Otherwise I guess it will be lots of trial and error!

Rob.

2

General Mach Discussion / Re: mach3 lathe homing and help

« on: September 07, 2015, 06:51:27 AM »

Thanks for the help Hood, that fixed it.

Rob.

3

General Mach Discussion / Re: mach3 lathe homing and help

« on: September 06, 2015, 06:48:49 PM »

Thanks Hood, much appreciated.

By the way, I tried renaming the 1024 to lset and reloading, but then it still shows Mill wizards. Do I need to change anything else?

Rob.

4

General Mach Discussion / Re: mach3 lathe homing and help

« on: September 06, 2015, 06:58:28 AM »

Thanks Rich, I will watch for it!

Rob.

5

General Mach Discussion / Re: mach3 lathe homing and help

« on: September 06, 2015, 05:20:22 AM »

I have just built a mini-lathe, and I am also having issues with Mach 3 turn screens and homing. In fact, I also don't like the manual and auto screen. In contrast, my mill works perfectly with the mill screenset.

But if I load the mill screen instead of lathe, homing works properly.

If the offer is still open, is there any chance of a copy of your screenset Hood, it looks perfect? I am quite happy to do some modifications if required, as I am a reasonable programmer.

Here is a link to my lathe so far:

www.cncprojects.net

Rob
Sydney