Messages

1

General Mach Discussion / Re: Artcam to Mach3 -partial file missing

« on: May 16, 2011, 04:14:03 AM »

Hmmm, I have Mach3, Im not sure what version it is though. Are the updates on here?
Thanks for your continued help!
Ryan.

2

General Mach Discussion / Re: Artcam to Mach3 -partial file missing

« on: May 15, 2011, 07:57:12 PM »

Thanks Hood,
Ive attached the one from the PC with the machine. Hope you can find something!
Thank you!!
Ryan

3

General Mach Discussion / Re: Artcam to Mach3 -partial file missing

« on: May 15, 2011, 06:15:06 AM »

This one is off my PC (not connected to the CNC) I think it is setup the same as my other one with the cnc controller from memory..
Is this what you are after?
Cheers!
Ryan

4

General Mach Discussion / Re: Artcam to Mach3 -partial file missing

« on: May 15, 2011, 06:00:54 AM »

Hi Hood,
Yep thats it! How would I get the XML?  Its on my other pc which I have set-up just for my cnc and it isnt connected to the net.
Thanks, please excuse my ignorance!
Ryan

5

General Mach Discussion / Re: Artcam to Mach3 -partial file missing

« on: May 15, 2011, 05:03:43 AM »

Ok great I''l try and attach it,
Thanks!
Ryan

6

General Mach Discussion / Re: Artcam to Mach3 -partial file missing

« on: May 15, 2011, 04:38:03 AM »

Thanks for the reply Hood,
But I have the full version.
Any other ideas?
Thanks!
Ryan

7

General Mach Discussion / Artcam to Mach3 -partial file missing

« on: May 15, 2011, 03:58:51 AM »

Hi I was wondering if someone can lead me in the right direction.
I'm having a few issues when I post Gcode to mach3 from Artcam.
I'm sure its just something simple, but it seems to only send through half the file.
For example, if I'm doing a 2mm deep engraving of the name 'Frank', it will send through 'ank',
I'm a bit stumped, as its all one tool path, it just breaks it in half for some reason.
It has also done it occasionally with the import of Hpgl files, send through say 60% of the file.
But most of the time its working great.
Thanks in advance,
Ryan.