Hello Guest it is November 30, 2021, 06:12:25 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - gas

Pages: 1
1
General Mach Discussion / Re: Anilam 1100 encoders
« on: April 30, 2011, 07:39:42 PM »
This control has a tach on the back of the motor. Position came from the glass scale.
I sold everything except for the motors and drives on Ebay.

2
General Mach Discussion / Re: Anilam 1100 encoders
« on: April 29, 2011, 08:27:23 AM »
Thank you,
I was looking for more detail.
What encoder part number?
Is there anything that will not require machining the motor shaft?
Probably a disassemble, clean and new bearings and brushes would not be a bad idea.

3
General Mach Discussion / Anilam 1100 encoders
« on: April 26, 2011, 03:58:14 PM »
I have an anilam 1100m with servos that use tachs.
What have you folks done for encoders?
Thanks

Pages: 1