Hello Guest it is May 19, 2024, 06:36:52 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - maquiza

Pages: 1
1
General Mach Discussion / Re: What motor size and driver should I use
« on: December 07, 2009, 06:07:24 PM »
I can sacrifice some performance on that machine, because that is better to a useless machine. Also the specs. from new of that machine are not so great regarding speed, It is a 1980 Brown & Sharpe 1500VC, and here in the manual say it is a 400in/min. rapid positioning speed ( I belived It was half of that ). I also send the information to cncdrive.com  and will reply here the answer.  Thanks,

2
General Mach Discussion / Re: What motor size and driver should I use
« on: December 07, 2009, 05:50:31 PM »
Thanks for your response. They are 90V DC.

3
General Mach Discussion / Re: What motor size and driver should I use
« on: December 07, 2009, 02:02:59 PM »
Simpson,
I have a big machine with DC Servos, GE, the X ans Y axis are 34 Amps. Cont. and the Z axis is 51 Amps. cont. Do you thing that the Dugong drive will work with this DC ServoMotors??
Thanks,
Jorge


4
General Mach Discussion / What´s the biggest machine using Mach3?
« on: November 28, 2008, 05:14:46 PM »
Hello, I just wonder, what is the biggest machine using Mach3?

Thanks,

Jorge

5
Any update on this project?? I am looking forward your work, because I have a Mazak H-20 that is very similar to your Mazak (electronics and Mechanics), only 4 axis.

Jorge

6
General Mach Discussion / Re: Pulse Coder- Way too many wires!
« on: March 27, 2007, 03:47:42 PM »
Hi David,

Can you tell me the status of your work, any good news? I want to do also a retrofit to my Mazak HMC, with fanuc 6BM control. It is exactly what you are doing, also with F/V converter. Can you give me pointers on what to buy and how to wire them?
I am following your treads with enthusiasm.

Thank You

George

7
Darek,
Do you think that this Glentek CEMF to Velocity Feedback Conversion Card will work as a  F/V converter?

8
Darek,


What would you do in my situation??


Thanks,

George


9
Hello Darek,

Do you think that is better a Rutex or original amps. with bigger servo motors? I have fanucs 20M and I am thinking of rutex R2020, but my servos are 213V , 18 A continuos, 40 A peak. Do you think rutex can handle it. Or can I use pixies with etach2 conected directly to the servo amp.

George.

Pages: 1