Messages

1

LazyTurn / dxf files

« on: August 15, 2015, 01:53:02 AM »

Where and how do I find the dxf file #32. I have read the manual, looked over the Lazyturn section and am drawing a blank.  Rely# 

2

LazyTurn / Re: LAZYTURN MANUAL COMMENTS

« on: August 13, 2015, 05:27:40 PM »

Rich
Sorry. Was trying to find how to access dxf files or Lazyturn. Still can"t find the rely key.

3

LazyTurn / Re: LazyTurn

« on: July 01, 2015, 05:09:53 PM »

I have done all of the above. LazyCam 3.00.2 installed. Also installed LazyTurn and it is version 1.1. Is this the latest version of Lazyturn?
Thank you

4

LazyTurn / LazyTurn

« on: July 01, 2015, 10:58:02 AM »

I have downloaded rev 8 of the manual, version 3.00 of LazyCam and version 1.1 of Lazyturn. Cannot find the links to upgrade LazyCam to 3.02 or what ever is the latest version of LazyTurn.
Can somebody help me find  the proper links?
Thankyou

5

General Mach Discussion / digitize wizard

« on: July 09, 2012, 07:48:09 PM »

i want to digitize an object that is x=3in., y=2in and z=.25

In setting up wizard
x=3.0,y=2.0,z travel height  .35 , z depth =0.0
x and y stepover.04  (approx 50% )
My probe has a 1/16 tip and I will carve using a 1/16 bullnose
Is this the correct way to setup?
When i go to carve should x,y,z all be 0