Hello Guest it is November 28, 2021, 03:03:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - 60hdrider

Pages: 1
1
FAQs / Re: motor movement
« on: January 27, 2014, 02:40:34 PM »
thanks for trying...

Bill

2
FAQs / Re: motor movement
« on: January 27, 2014, 02:37:10 PM »
tried that and restarted the software and no change

3
FAQs / Re: motor movement
« on: January 27, 2014, 02:16:56 PM »
kernel speed did not help my problem

4
FAQs / Re: motor movement
« on: January 27, 2014, 01:56:54 PM »
I have hade my motor tuning all over the place and still no movement

5
FAQs / motor movement
« on: January 27, 2014, 10:55:31 AM »
I have been using Mach 3 for a while now and my computer crashed. I reconnected another computer that I had been using to try my programs (simulating). I lost all my inputs and output configurations but that is not the real problem. I have gone thru the setup procedures and should have enough information for motor movement but do not. I can hear them react to commands but no movements. I do have them enabled in Ports an pins. Please help.

Bill

Pages: 1